andy
New Member
Posts: 2
|
Post by andy on May 23, 2023 22:21:57 GMT
Hi all I have acquired a Cyc-auto fitted with a Scott engine unfortunately the big end and main bearings require replacement, I don't think the mains will be too challenging, the big end however may be different so :- a, anyone have a source for a replacement crankshaft or b, a source of oversized 1/4 rollers(say+30-40'')or c, know of a alternative con-rod 1,1/4 and pin 3/4 (4 inch between centers) I have been offered a complete engine but it seems a disproportionate solution. Thanks Andy
|
|
andy
New Member
Posts: 2
|
Post by andy on May 31, 2023 6:17:51 GMT
Is anyone familiar with these engines? I now have another crank! Dose the drive side petroil feed that lubricates the mainshaft bushes then carry on through the clutch shaft? TIA Andy
|
|